When the drain pump is pumping out the leftover water, the START/RESET button will blink.
Once the START/RESET button is selected, the drain pump will remove any residual water left over in the bottom of the dishwasher. Pressing the START button once again should reset the dishwasher. – If there is a power failure, the START button may blink when the power comes back ON. GE Dishwasher – Press START button Once To Start – Twice To RESET NOTE: The GE dishwasher wash cycle can always be canceled by pressing the START/RESET button. This should get the dishwasher working again. (Only press the START button 1 time when you begin a wash cycle) To stop the flashing lights or steady ON lights, press the START button 1 more time to resume normal operation. – If ALL the lights are either blinking or constantly ON, the START button on the dishwashers display was accidentally PRESSED MORE THAN ONCE. Pressing the button twice resets the dishwasher. Pressing the button once starts the cycle. – When your GE dishwasher wash cycle will not start and all the lights are on, the START/RESET button may have been pressed more than once. GE Dishwasher – All Lights Are On – Blinking
Plug the dishwasher back in and it should be reset and ready to begin a wash cycle.
If this does not reset the dishwasher and stop the blinking lights or beeping sounds, then simply unplug or remove power to the dishwasher for 10 minutes. – If you have blinking lights on the display panel of your GE dishwasher: Try pressing the START/RESET button.
GE DISHWASHER POWER QUIET 3 MANUAL HOW TO
How to Reset Flashing lights and Beeping Noises for most GE dishwashers models:
0 kommentar(er)
